Filter
Top Products
38
To enable the DA-98 to receive digital input from the TDIF-1, press the DIGITAL IN button on the
front panel.
When the timecode output of the video recorder is generated after being converted to MTC, the
MODE dip switch 6 on the SY-88 rear side is set to OFF. (If this switch is set to ON, the timecode
recorded on the tape is converted into MTC and the resultant output is generated.)
Use the tape where the recorded timecode has the same frame rate as that of the SMPTE timecode
output generated from the video. It is impossible to perform operation synchronized with the
SMPTE timecode of the video recorder if no timecode is recorded in the tape or there is failure in
coincidence of the frame rate.
Turn on the CHASE switch of the DA-98.
Set the dipswitch 8 at ON the SY-88 board.
While ALL INPUT is ON; no playback is generated. To realize playback, ALL INPUT should be set to
OFF.
A ‘CHANNEL STATUS CRCC ERROR’ may be displayed during Digital
recording from the DA7.
This is; however, a message in regards to the sub-code signal, even
with this being displayed proper audio recording and playback
should be performed.