Filter
Top Products
28
WR-DA7 setting
To use the WR-DA7 as a slave unit, set the SOURCE SELECT to ‘WCK IN’ in the INPUT SET window
of the D-I/O Setup Section on the MASTER unit.
(For wordclock synchronization using the DA98’s connection slot, set the SOURCE SELECT to
‘SLOT1’ on the MASTER WR-DA7. Keep ‘WCK IN’ on the SLAVE unit.)
To establish communication between the tandem WR-DA7 units, set the PORT SELECT to ‘TO PC’
in the SERIAL I/O SETUP in the MIDI SETUP screen for both the MASTER and SLAVE units. Then
set the baud rates to the same value.
To send and receive MIDI messages, set the PORT select of Gen.Rx and Gen.Tx to ‘MIDI’ in the
MIDI SETUP screen. On the TANDEM SLAVE unit, set the SEND/RECEIVE of the various MIDI mes-
sages to ‘THRU.’
For MMC set the MMC PORT to ‘MIDI’ in the MIDI SETUP window for the same MMC channels to
be received on the BRC.
For MTC reception on the WR-DA7, set MTC PORT to ‘MIDI’ in the MIDI SETUP window of the
TANDEM (MASTER) unit.
To display the MTC timecode, set the TIME BASE to ‘MTC’ in the EXECUTE window of AUTOMA-
TION SETUP Window.
(To use the SMPTE timecode connect the WR-SMPTE option card, and set the TIME BASE to
‘SMPTE.’ in the EXECUTE window of AUTOMATION SETUP Window.)
DA-98, 38 setting
Since the DA-98 and 38 receive digital input data from the TDIF-1, press the DIGITAL IN switch on
the control panel.
To set the machine ID numbers of the DA-98 and 38, ID: 1 is assigned to the DA-98. The machine
ID numbers are set to 1, 2, 3, and 4 in the order of cable connections from SYNC OUT to SYNC
IN.
Select the sampling rate of the DA-98 to INT 48k or INT 44.1k. The sampling rate of the DA-98 is
automatically set off the tape that≈ fs being used.
Operation of the DA-38 is synchronized with the DA-98, as a slave unit for the DA-98. Therefore,
when the ID is set for any value other than 1, the DA-38 is set to the wordclock from the PW-88S
SYNC cable.
Press the CHASE switch of the DA-38 front panel with the machine IDs 2, 3, and 4 to select CHASE
to ‘ON’ so that synchronization can be performed with the master DA-98.
While ALL INPUT is ON; no audio is played back. For playback ALL INPUT should be set at OFF.