Yamaha 01X Musical Instrument User Manual


 
88
Function Tree/Function List
01X Owner’s Manual
Before Using Basics Section AppendixGetting Started Reference
3 REMOTE AUTOMATION SETUP
u
FADER TOUCH
TIMEOUT
100 msec –
Determines the amount of time that the 01X “waits” for fader movement
before turning off automation recording. This can be set over a range of 100
ms – 5000 ms, in 100 ms units. When a fader has not been moved for more
than the time set here, the 01X stops writing automation data. (This is also
referred to as “touch-out”; see page 15.) The [SEL] button flashes while auto-
mation writing is active (touch-in). When this parameter is set to “ ” (infin-
ity), there is no “time out” and writing continues indefinitely. You can
manually stop automation writing by pressing the [SEL] button when it is
flashing (page 17).
No 15
PATCH [UTILITY] Channel knob 2
1 INPUT PATCH (IN1-4) (Input Channels 1 – 4)
2 INPUT PATCH (IN5-8) (Input Channels 5 – 8)
q
NONE/AD1 – 8/
DIN-L/DIN-R IN1 – 8
Determines the input signal routing for input channels 1 – 8. This allows you
to route a specific hardware source (MIC/LINE INPUTS 1 – 8, or DIGITAL
STEREO IN L/R) to a desired channel input. Turning the knob immediately
changes the routing. The settings “AD1” – “AD8” correspond to MIC/LINE
INPUTS 1 – 8, while “DIN-L” and “DIN-R” correspond to the DIGITAL
STEREO IN signals. To disable input for the desired channel, select “NONE.”
As the default setting, MIC/LINE INPUTS 1 – 8 are assigned to input
channels 1 – 8, respectively.
The same input signal can be simultaneously routed to several different
input channels.
The Input Patch settings made here can be stored to the Input Patch
Library (page 89).
No
27
61
e
e
No
t
No
u No
Knob
Function name/
settings
Explanation Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [ / ]
MIC/LINE INPUT jack
(AD1)
MIC/LINE INPUT jack
(AD2)
MIC/LINE INPUT jack
(AD3)
MIC/LINE INPUT jack
(AD4)
MIC/LINE INPUT jack
(AD5)
MIC/LINE INPUT jack
(AD6)
MIC/LINE INPUT jack
(AD7)
MIC/LINE INPUT jack
(AD8)
Input Channel 1
(IN1)
Input Channel 2
(IN2)
Input Channel 3
(IN3)
Input Channel 4
(IN4)
Input Channel 5
(IN5)
Input Channel 6
(IN6)
Input Channel 7
(IN7)
Input Channel 8
(IN8)
INPUT PATCH