Filter
Top Products
To continue a recording from the end of a
previous recording
1 Press the END ID SEARCH button in stop mode or
during playback.
The button starts flashing. The tape is rewound to the
beginning and then fast-forwarded to the point where
the end ID signal is written (End search function). The
light of the button goes off when the tape stops.
2 Start recording from the point where the tape stops.
Tune numbers and absolute time will be continued from
the previously recorded contents.
The end ID signal of the previous recording is
automatically erased.
To erase the end ID signal
An end ID signal is automatically erased when successive
recording is performed using the end search function. To
erase an end ID signal without successive recording,
perform the following procedure.
When the tape stops after end search operation, press
the END ID ERASE button.
The button starts flashing. When the end ID signal is
erased, the tape stops. (While erasing the end ID signal,
the tape is advanced for a few seconds and the END-ID
indicator flashes.)
To erase the recorded contents
When a recording is made over a previous recording, the
previous recording is automatically erased. To erase the
recorded contents without making a new recording, perform
the following procedure.
1 Set the INPUT selector to the ANALOG position.
2 Load the tape in the cassette holder.
3 Turn the REC LEVEL control fully counterclockwise
to 0 (MIN).
4 Press the REC button
5 Press the PLAY button
The previously recorded contents will be erased.
21