Filter
Top Products
MV800 — Owner’s Manual
8 About the Accessories
About the Accessories
Euro-block Connectors
If you decide to use Euro-block connectors, please use the supplied connectors and attach as shown in the
illustration below.
q Turn the POWER switch OFF.
w Loosen the screws holding the cover in place and remove the cover.
Euro-block connector
e Attach the Euro-block connectors.
1. If the hole for the wire is closed, turn the screw on the top of the connector to the left to open.
2. Insert the wires according to the jack’s pole display, and turn the upper screw to the right to secure the
wire.
3. Connect the Euro-block connector to the mixer’s jack.
r Replace the cover and re-attach it in its original location.
Caution:
Electric shock may occur if the Euro-block connectors are used without the cover attached.
Feet
Four rubber feet are supplied with the mixer.
According to the orientation that the device is installed, attach the rubber feet to the surface that is at the
“bottom” of the mixer.
After wiping any dust and grime on the surface of the mixer, remove the adhesive’s protective cover on the top of
the feet and attach to the mixer.
Secure with a minus (-) driver.