Filter
Top Products
S90 XS/S70 XS Editor Window: Bottom section
S90 XS/S70 XS Editor Owner’s Manual
32
Bottom section
1 Controller Set status
This section indicates which controller of the S90 XS/S70 XS (either built-in or connected) is used as the
Control Source of the Controller Set edited in the RCV/Control Set window.
1 Part
Indicates the current Part. When [Voice]/[Multi] is set to “Voice” (Voice mode is enabled), in the Voice
mode, this indication is fixed to “1.” When the [Voice]/[Multi] is set to “Multi” (Multi mode is enabled), in the
Multi mode, this indication is determined by selecting the Part in the Mixer section.
2 Control Source
Indicates the six controllers as source of the Controller Set. The abbreviations for the Controllers are as
follows:
3 On/Off status
When a lamp is turned on, a certain function (Destination) is assigned to the corresponding Source
(controller). When a lamp is turned off, no function (Destination) is assigned to the corresponding Source
(controller).
2 Quick Setup
From this section, you can instantly call up appropriate settings related to the MIDI parameters.
n The settings of the S90 XS/S70 XS instrument made via the operation here cannot be saved as an Editor file.
You can select a template from 1 – 3. On the S90 XS/S70 XS instrument, this section is the same as the
Quick Setup parameter on the Utility Quick Set display.
n The parameters set via the Quick Setup can be edited on the Hardware Utility window (page 43).
Indication Control Source Indication Control Source
PB Pitch Bend Wheel BC Breath Controller
MW Modulation Wheel AS1 ASSIGN 1 knob
AT After Touch (keyboard) AS2 ASSIGN 2 knob
FC Foot Controller FC2 Foot Controller 2
FS Foot Switch AF1 ASSIGNABLE FUNCTION 1 button
RB Ribbon Controller AF2 ASSIGNABLE FUNCTION 2 button
1
2
5
7
3
6
4
1
3
2