Filter
Top Products
92
The Variation Parameters
The variation stage includes reverb, delay, echo, modulation, distortion, wah, and a range of other
effects.
Type
• Variation Type
• Settings: NO EFFECT, HALL 1, HALL 2, ROOM 1,
ROOM 2, ROOM 3, STAGE 1, STAGE 2, PLATE, DELAY
LCR, DELAY L,R, ECHO, CROSSDELAY, ER1, ER2, GATE
REV, REVRS GATE, KARAOKE 1, KARAOKE 2,
KARAOKE 3, CHORUS 1, CHORUS 2, CHORUS 3,
CELESTE 1, CELESTE 2, CELESTE 3, FLANGER 1,
FLANGER 2, SYMPHONIC, ROTARY SP, TREMOLO,
AUTO PAN, PHASER, DISTORTION, OVERDRIVE, AMP
SIM, 3-BAND EQ, 2-BAND EQ, AUTO WAH, PITCH
CHNG, AURAL EXCT*, TOUCH WAH, WAH+DIST,
COMPRESSOR, NOISE GATE, THRU
Selects the variation type, or “NO EFFECT” if no
variation effect is required. Refer to the separate
“List Book” for brief descriptions of each of the
variation types.
* Aural Exciter®is a registered trademark of and
is manufacutured under license from Aphex
Systems Ltd.
Type-Specific Variation Parameters
• See separate “List Book”
Each of the variation types, selected via the “Type”
parameter, above, has a different set of parameters
that specify the actual variation effect sound. Refer
to the separate “List Book” for information on the
individual parameters for each variation type.
AT VarCtrl
• Aftertouch Variation Control
• Settings: -64 … +63
This parameter only becomes available when the
“VarConnect” parameter (page 93) is set to “INS”
(i.e. when the variation stage is connected as an
insertion effect). Aftertouch variation control
allows one of the selected variation effect param-
eters to be controlled in real time via keyboard
aftertouch pressure. The parameter which can be
controlled is individually preset for each variation
effect type (see the separate “List Book”). The “AT
VarCtrl” parameter determines to what degree the
effect parameter is affected by aftertouch pressure.
For example, if the TREMOLO effect is selected
aftertouch controls the “LFO Frequency” param-
eter. In this case higher positive “AT VarCtrl”
values cause increased aftertouch pressure to
increase the LFO speed, while higher negative
values cause increased aftertouch pressure to
decrease the LFO speed. If this parameter is set to
“+00” aftertouch control has no effect.
AC1VarCtrl
• Assignable Controller 1 Variation Control
• Settings: -64 … +63
This parameter only becomes available when the
“VarConnect” parameter (page 93) is set to “INS”
(i.e. when the variation stage is connected as an
insertion effect). Assignable Controller variation
Effects & Effect Editing