Filter
Top Products
93
higher the value, the more variation signal is sent
to the chorus stage. If this parameter and the PLAY
mode “VarRtn” parameter are both set to values
higher than “001”, the output of the variation stage
will be sent in corresponding amounts to the input
of the chorus stage and the main outputs. This
parameter becomes available when the
“VarConnect” parameter is set to “SYS” (i.e. when
the variation stage is connected as a system effect.)
SendVar➔Rev
• Variation-to-Reverb Send Level
• Settings: 000 … 127
Sets the amount of signal sent from the output of
the variation effect stage back to the input of the
reverb effect stage (see diagram on page 87). The
higher the value, the more variation signal is sent
to the reverb stage. If this parameter and the PLAY
mode “VarRtn” parameter are both set to values
higher than “001”, the output of the variation stage
will be sent in corresponding amounts to the input
of the reverb stage and the main outputs. This
parameter becomes available when the
“VarConnect” parameter is set to “SYS” (i.e. when
the variation stage is connected as a system effect.)
VarConnect
• Variation Connection Mode
• Settings: INS, SYS
Determines whether the variation effects stage
functions as an insertion effect (“INS”) or as a
system effect (“SYS”). See the diagrams and
explanations on pages 86 and 87 for the difference
between these connection modes.
control allows one of the selected variation effect
parameters to be controlled in real time via assign-
able controller 1 (page 54). The parameter which
can be controlled is individually preset for each
variation effect type (see the separate “List Book”).
The “AC1VarCtrl” parameter determines to what
degree the effect parameter is affected by the
controller. For example, if the TREMOLO effect is
selected the controller affects the “LFO Frequency”
parameter. In this case higher positive
“AC1VarCtrl” values cause increased controller
settings to increase the LFO speed, while higher
negative values cause increased controller settings
to decrease the LFO speed. If this parameter is set
to “+00” assignable controller 1 has no effect.
Var Pan
• Variation Pan
• Settings: L63 … C … R63
Sets the pan position of the variation effect sound
— i.e. the perceived position of the variation effect
sound within the stereo sound field. A setting of
“L63” sets the variation sound full left, “R63” sets
the sound full right, and “C” places the sound in
the center. Intermediate settings pan the variation
effect sound to corresponding positions in the
stereo sound field. This parameter becomes avail-
able when the “VarConnect” parameter is set to
“SYS” (i.e. when the variation stage is connected
as a system effect.)
SendVar➔Cho
• Variation-to-Chorus Send Level
• Settings: 000 … 127
Sets the amount of signal sent from the output of
the variation effect stage back to the input of the
chorus effect stage (see diagram on page 87). The
Effects & Effect Editing