Configuring Virtual Circuits 145
Adding Voice
Compression Module
VCC Circuits
To configure a VPC/VCC virtual circuit to connect data ports, follow these steps:
You must configure at least one VCM VCC circuit before you can configure any
VCM subchannel circuits.
1 When you are prompted to select the virtual circuit type, as shown earlier in
Figure 105, enter 3 to create a VCM VCC circuit.
A screen appears, listing the modules available to assign as side A of the virtual
circuit, as shown in Figure 108.
Figure 115 Selecting a Slot for Side A of a VCM VCC Virtual Circuit
2 Enter the number corresponding to the slot in which the Voice Compression
module is installed (7 or 8) to assign the VCM to side A of the circuit.
The Add Virtual Circuit screen displays the selected slot number and port type, lists
the parameters you will enter for side A of the circuit, and prompts you to set the
first parameter, as shown in Figure 116.
3 Follow the prompts that appear at the bottom of the screen, pressing [Enter] after
each entry. Default values are listed in square brackets ([ ]) at the end of each
prompt.
Your settings are added to list of parameters at the top of the screen as you enter
them. You must enter a setting for all the parameters for which you are prompted
in order to add a circuit. Press [Delete] to back up to a previous selection.
CAUTION: For voice compression circuits, select the Shaper Number
corresponding to the maximum shaper value (typically Shaper Number 15).
Make sure that Early Packet Discard is disabled (set to no) for voice compression
circuits.
