Classe Audio SSP-800/CT-SSP Manual

A SERVICE OF

next previous

28

Connect the Main Analog Audio Outputs, either RCA or XLR, from the rear

panel of the SSP to the corresponding inputs on your amplier(s) as follows:

• ConnecttheSSPFrontLeftandFrontRightoutputstotheinputs

of the amplier(s) designated for the Front Left and Front Right

speakers, respectively.

• ConnecttheSSPcenteroutputtotheinputoftheamplier

designated for the center channel speaker.

• ConnecttheSSPLeftSurroundandRightSurroundoutputstothe

inputs of the amplier(s) designated for the Left Surround and Right

Surround speakers, respectively.

• Ifyouaresettingupa7.1-channelsystem,thenalsoconnecttheSSP

Left Rear and Right Rear outputs to the inputs of the amplier(s)

designated for the Left Rear and Right Rear speakers, respectively.

• Ifyouareusingasubwoofer,connecttheSSPsubwooferoutputto

the input of the designated amplier or powered subwoofer.

NOTE: Make sure connections from the subwoofer output go only to an

amplier connected to a subwoofer, as low frequency signals can damage a

small full-range speaker not designed for high output bass reproduction.

Verifythateachcableisclearlylabeledsothatyoudon’tmixthemup.When

connecting a cable, make sure the cable has a good connection and is rmly

attached to the rear panel connectors on both the amplier and the SSP.

eSSP-800/CT-SSPalsoprovidestwoAuxiliary analog audio outputs. See the

Rear Panel section for more details about the Auxiliary outputs.

Step 5 Connect the loudspeakers to the amplifiers.

Important!

Verify that the power amplifier(s) is plugged in but powered

OFF before connecting to the SSP!

Connect each loudspeaker to its designated amplier(s) channel. Pay close

attention to the phase of the speaker connections – always connect an amplier’s

red (+) terminals to the red (+) terminals of the loudspeaker. Likewise, connect black

(–) terminals to black (–) terminals.