Classe Audio SSP-800/CT-SSP Manual

A SERVICE OF

next previous

29

Step 6 Power up the system!

NowyouarereadytopowerupyourSSPandyoursurroundsystem.

• TurntherearpanelpowerswitchoftheSSPtoON.

•

e initial power-up cycle of the SSP takes approximately 90 seconds.

During this time, the blue LED on the standby button ashes. (For the

CT-SSP,thestandbybuttonitselfwillashblue.)

• Whenthepower-upcycleiscomplete,theSSPentersStandbymode.

e LED (or standby button) stops ashing but remains illuminated,

indicating that the SSP is in Standby mode. Refer to the Front Panel

section, for more details about Standby mode.

• PresstheStandby button or the front panel touchscreen to bring the

SSP to its fully ON mode. e front panel touch screen displays a

blue screen with an “initializing” message and then switches to the

home page of the menu system. Refer to the Menu System section

found later in the manual for more information.

e physical setup of the SSP and system components is complete.