16 Administrator Guide for SAS 9.1.3 Foundation for Microsoft Windows
From the Select Components dialog, interactive users are able to specify the software that
they would like to install to their local machines.
The Select Licensed Software button uses the SAS Installation Data file that you provided to
determine which software is licensed, and pre-selects just those components. Any non-
licensed components that you placed into the network image when you created it will also be
available for installation to the user here.
If your end users are running SAS Setup from an image created for Client Users, they will not
be prompted to select software to install, but will have access to the software that you placed
in the network image when you created it. Only a minimal set of required components will be
installed locally on their machine.
Using Record Mode with SAS Setup
Unlike the System Requirements Wizard, SAS Setup prompts for many user responses during
interactive use. When using SAS Setup in Quiet Mode, these responses are too numerous to
be specified on a single Quiet Mode command line. Instead, they are specified in a file, which
is created using Record Mode.
To launch SAS Setup in Record Mode, issue one of the following commands (without the
parenthetical comment), depending upon the type of end user:
• Client Users: <Source Path>\SAS\SETUP.EXE record
• Personal Users: <Source Path>\Disk1\SAS\SETUP.EXE record
SAS Setup will prompt you for the location where your quiet record file will be placed.
