42 Administrator Guide for SAS 9.1.3 Foundation for Microsoft Windows
Read Start Copying Files
At this point in the installation, Setup has enough information to start copying the program
files.
Click Next if you are satisfied with the settings.
Or, if you want to review or change any settings, click Back to return to the Select File Types
window.
Click Cancel to exit Setup.
Read Confirm Update if Setup displays this window.
This window appears when Setup finds a file extension, such as .LOG, that is already used
by another application. Setup can associate files that use this extension for use by SAS,
but this change could affect other applications. You can change your current preference
so these files will be associated with SAS, or you can leave the previous choice in place.
Here are the choices you can make from this window:
• If you would like Setup to change the file extension association and enable SAS
functionality, click Yes to make SAS 9.1.3 the default application for files using
this extension.
• Click No to leave the previous association for the file extension in place.
In addition, you can check the box at the bottom of the window before you click Yes or
No, if you would like all other file extensions already in use to be handled in the same
manner.
Click Cancel to exit Setup without completing the procedure.
There are two alternatives for the final dialog in the sequence:
Read SAS Setup Complete if Setup displays this window.
At this point, Setup has installed the SAS software. If you want to launch SAS 9.1.3 now,
click that checkbox. If you want to view the Post-Installation Guide now, click that
checkbox.
Click Finish.
Read SAS Setup Complete if Setup displays this window.
At this point, Setup has copied all the required files to your computer. However, some
files could not be updated because they are in use. These will be updated automatically
when you reboot your computer.
Click on one of the two radio buttons:
• Yes, I want to restart my computer now.
• No, I will restart my computer later.
If you choose to reboot, close all open applications and remove any floppy disks from the
disk drives.
Verify that all virus-scanning software has been disabled after the computer restarts.
Click Finish.
Dialogs Used More than Once in Setup
The following three dialogs appear as needed during SAS Setup Wizard procedures:
Read Setup Status
This dialog is displayed while Setup performs the requested operations. No action is required.
If you click Cancel, you will exit Setup, and the program will not be installed.
Read Exit Setup
Setup can be completed later, but if you quit Setup now, the program will not be installed.
Click No to resume Setup, or click Yes to quit.
