Mix Running — displayed while writing new
automation data.
Mix Review — displayed as soon as you roll back
and when you play forward to replay previous
automation data.
The number after Mix Review (in this case 23)
indicates the number of times you have rolled back
in the current mix.
When the DAW returns to Play, previously written automation data is replayed. If no faders are returned to
write, all faders in write at the start of the mix will drop back into write at the point at which the DAW was
rewound (the ‘rollback point’, and the mix status will return to Mix Running. Whilst in Mix Review you may
rollback as many times as required to allow the mix to be built up fader by fader. Each time a rollback takes
place, the rollback counter in the mix status display increments. Faders in write at a rollback point will
automatically switch to write when the system plays through the rollback point.
DDeeddiiccaatteedd AAuuttoommaattiioonn BBuuttttoonnss
A group of dedicated automation buttons are provided in the centre section, just above the transport buttons:
The CANCEL button is used to cancel a mix and return to the Mix List page. Pressing the END button saves
the current mix to flash memory and also returns you to the Mix List.
Pressing the ALL REPLAY button simply puts all faders and cuts, that are in write, into Replay status, which is
useful for flipping all the currently recording controls into Replay without stopping or rewinding.
The other buttons in this group are described on the following pages.
TRANSPORT
AUTOMATION
TRIM
MOTORS
OFF
TRIM
LOK
SNAP
AUTO
T/OVER
DISCARD
END
REVISE
JOIN
ALL
REPLAY
CANCEL
STOP PLAY
RECORD
P
roject 1 :: Title 2
AutoAutoAutoAutoAutoAutoAutoAutoAuto AutoAuto
M
ix Review 23
Misc
Moff
TR
TLock
Trim Snap
AT
SSL
Auto
CS
Lnks Misc
End Discard
R
evise
J
oin
00 : 02 : 12 : 23
Duality Operator’s Manual
5
5
-
-
7
7
Dedicated Automation Buttons
