Selecting a DAW Channel for Plug-In Control
Select EDIT mode on the Master Control Panel then use the channel SEL buttons to choose the channel you
wish to edit. The EDIT flag in the channel meter will light. The DAW will highlight the selected channel and the
currently selected plug-in. Press ALT to display the plug-in window.
Alternatively, select a channel by double clicking on one of the insert points in the Mix window. Note that on
some versions of Pro Tools this is the only way to change between blocks of channels (1-8, 9-16, 17-24).
Note: Bank switching channels leaves the Plug-In Editor with the channel assigned to it.
The channel EDIT tally will show this.
Timecode/Bars & Beats/Samples Display
The on-screen timecode readout can be assigned to display either timecode (SMPTE/EBU), Feet/Frames,
Bars/Beats or samples. This display will follow the setting selection made within your DAW. Please refer to your
DAW manual for further details.
Plug-In Display Modes
There are three display modes, Insert, Parameter and Assign, all of which are selected using the soft button
ASSIGN and INSERT/PARAM buttons below the D-pots.
Viewing Current Inserts (Insert Mode)
Press the INSERT/PARAM button till the INSERT/PARAM box reads INSERT; the Plug-in Editor is now in
Insert mode. In this mode, the four D-pots represent four insert points on the selected channel. The currently
assigned plug-ins are displayed above each D-pot. The name of the currently active plug-in will flash. Additional
insert points can be displayed using the paging buttons.
The four D-pot push switches can be used to select an insert slot for editing or for plug-in assignment – see
below.
DAW Control Guide
3-18
Duality Operator’s Manual
