4 - 69
ENG
ENGINE ASSEMBLY AND ADJUSTMENT
●Turn the crankshaft counterclockwise until
the TDC mark 3 is aligned with the station-
ary pointer 4 on the crankcase cover.
●Place the timing chain onto the cam
sprocket.
●Install the cam sprocket onto the cam-
shaft, and finger tighten the sprocket bolt.
NOTE:
● When installing the cam sprocket, keep
the timing chain as tense as possible on
the exhaust side.
● Align the pelete mark 5 on the cam
sprocket with the stationary pointer 2 on
the cylinder head.
●Insert your into the timing chain tensioner
hole, and push the timing chain damper
inward.
●While pushing the timing chain damper,
be sure cam sprocket match mark 5 align
the cylinder head match mark 2.
●If marks is aligned, tighten the cam
sprocket bolt.
NOTE:
Hold the starter pulley 6 by the Rotor
Holder to tighten the bolt of the cam
sprocket.
●If marks do not align, change the meshing
position of sprocket and chain.
●Remove a safety wire 7 from the timing
chain.
*********************************
T
R
.
.
Bolt (cam sprocket):
60 Nm (6.0 m • kg, 43 ft • lb)
Rotor holder:
P/N. YU-01235, 90890-01235
10.Install:
● Timing chain tensioner assembly
*********************************
Installation steps:
●Remove the chain tensioner cap 1 from
the chain tensioner assembly 2.
4
