4 - 73
ENG
ENGINE ASSEMBLY AND ADJUSTMENT
3.Install:
● Rear wheel drive assembly and swing-
arm.
NOTE:
● Before installing the swingarm. Lubricate
the following parts.
Swingarm pivot side:
1) Bearings 1
2) Oil seals 2
3) Collars 3
4) Pivot shafts 4
Drive shaft side:
1) Drive shaft splines 5
2) Coupling gear splines 6
● Before installing the swingarm, do not for-
get to fit the drive shaft 7.
● Insert the drive shaft 7 into the universal
joint 8 properly.
4.Connect:
● Rubber boot 1
5.Install:
● Pivot shafts 2 (swingarm)
● Locknut 3 (pivot shaft-right)
NOTE:
Temporary tighten the pivot shafts and
locknut, do not torque them at this point.
6.Check:
● Drive shaft operation
*********************************
Checking steps:
●Block the front wheels, and elevate the
rear wheels by placing the suitable stand
under the flame.
●Move the rear wheels back and forth.
●Check the drive shaft operation. If there is
unsmooth operation recheck the drive
shaft condition of installation.
*********************************
Lithium-soap Base Grease
4
