Filter
Top Products
15
E
via MIDI. Accordingly, the value 1 enables MIDI controller #18 so that you can modify or replace presets
with a remote MIDI device or a sequencer. In this case the actual settings will be stored directly to the location
that corresponds to the controller value.
+ Attention! Since the store enable mode allows you to access memory locations directly via
MIDI, it is possible that stored presets will be replaced or altered if controller #18 messages are
sent on the same MIDI channel. The purpose of this mode is to facilitate MIDI backup and
restore operations without express confirmation at the FEEDBACK DESTROYER PRO. It is
therefore recommended to disable (flag=0) this mode as soon as the intended data transfer
has ended. This is done automatically when you switch off the FEEDBACK DESTROYER PRO.
On the sixth, and presently the last, page you can access the System Exclusive functions. This is indicated
by a d (for dump) in the display. To the left of this d a number is displayed:
- 0 means that no SYSEX data will be sent or accepted.
- 1 will enable the FEEDBACKDESTROYERPRO to receive data. When STORE is pressed the unit will wait
for data, this
is shown by flashing dots (LEDs) in the display. The MIDI button LED flashes signaling that SYSEX data is
being received.
- 2 will enable the FEEDBACKDESTROYERPRO to send a bulk dump. Start your sequencer and press
STORE on the unit to start the transmission.
If you press the IN/OUT key again on the fifth page, the FEEDBACKDESTROYERPRO quits MIDI setup
mode.
To load these settings again, select 1, press STORE and start your sequencer. If you press IN/OUT again, you
will leave the MIDI setup. You can at all times press any other key to leave the MIDI setup directly.
+ During a bulk dump all audio functions of the FEEDBACK DESTROYER PRO will be deactivated.
The full-featured MIDI implementation of the FEEDBACK DESTROYER PRO allows for easily integrating the
FEEDBACK DESTROYER PRO into any MIDI system.
s MIDI IN
Any MIDI data sent to the FEEDBACK DESTROYER PRO (sequencer, MIDI footswitch, etc.) are received via
the MIDI IN jack. For example, if you wish to use the FEEDBACK DESTROYER PRO as an effects device for
your guitar rack, you can connect the MIDI IN jack to a MIDI footswitch that allows for selecting program
presets. If your rack includes another MIDI effects device (e.g. a multi-effects processor), the data sent from
the MIDI footswitch can be routed via the FEEDBACK DESTROYER PROs MIDI THRU jack to your multi-
effects processor.
s MIDI THRU
The MIDI THRU jack is used to loop through incoming MIDI data, i.e. any control data received at the MIDI IN
of the FEEDBACK DESTROYER PRO will be transmitted via the MIDI THRU jack to other MIDI devices/
instruments.
s MIDI OUT
The MIDI OUT jack allows for transmitting MIDI data that originate from the FEEDBACK DESTROYER PRO.
We are currently developing a software editor which will allow for storing single items of the
FEEDBACKDESTROYER PRO`s internal data on an external medium. Thus, it will be possible to archive
FEEDBACKDESTROYERPRO settings and presets on a computer, sequencer or MIDI data recorder. Both
MIDI Control Change and MIDI Program Change commands will be transmitted when you edit or recall filter
settings. Detailed information on this future software editor are available from our BEHRINGER hotline
(tel.+49(0)2154-920666), our international distributors and/or our Internet homepage http://www.behringer.de.
3. APPLICATIONS
The BEHRINGER FEEDBACK DESTROYER PRO features a high level of flexibility not only in the field of
feedback elimination. The following chapter describes some other possible applications for your
FEEDBACKDESTROYER PRO.
3. APPLICATIONS