Filter
Top Products
19
E
3.7 Special remarks
3.7.1 Digital overflow
When using the FEEDBACK DESTROYER PRO as a parametric equalizer (Parametric EQ mode) and
applying extreme attenuation values in the low end range of the frequency spectrum (below 50Hz), you
should perhaps set several filters to process the same frequency. Depending on the amount of attenuation
applied, the use of only one filter may lead to slight distortion, which produces interference in the signal path.
This is a natural physical phenomenon which should be avoided. Use for example two filters adjusted to a
signal attenuation of about -12dB (with the same frequency and bandwidth). This produces the same effect
achieved with one filter set to -24dB.
3.7.2 Tuning in P.A. and monitor systems
With the FEEDBACK DESTROYER PRO you can improve the protection against feedback even before the
show begins, by tuning in your sound reinforcement system: after the system has been set up completely,
open all microphone channels and activate Single-Shot mode on your FEEDBACK DESTROYER PRO. Then,
slowly move up the monitor and master faders until feedback comes in. Without the
FEEDBACKDESTROYERPRO you could not increase the volume level of your system any further. With your
FEEDBACK DESTROYER PRO, however, you can considerably enhance the system headroom! Move the
faders further up, and the first feedback signal will be suppressed by the FEEDBACK DESTROYER PRO.
Continue to move up the faders until about three or four filters are suppressing various feedback signals.
Subsequently, cut back the volume to the level required for the show. In this way, you can be sure that there is
enough system headroom should it be necessary to raise the volume level during the concert.
If you have more than one FEEDBACK DESTROYER PRO for the monitor path, you should use these devices
to protect critical signal paths. Experience has shown that musicians want to have the volume of their instru-
ment increased on the monitor as the concert goes on. With the FEEDBACK DESTROYER PRO you can turn
up the volume without having to fear feedback problems. When the show begins you should set several filters
to Auto mode in order to suppress feedback produced by moving (vocal) microphones. In Auto mode, the
FEEDBACK DESTROYER PRO automatically tracks and suppresses feedback signals with varying frequen-
cies.
4. TECHNICAL BACKGROUND
The steady development of modern sound reinforcement systems has made it possible to produce almost any
level of loudness. Yet, the increase in loudness goes in line with a need for optimized audio quality. Today,
audiences expect to hear a powerful and transparent sound. Nothing can spoil a live event more than interfer-
ence and feedback.
High volume levels and the use of ever sophisticated monitor systems with a great number of speaker boxes
have increased the potential risk of feedback loops. Up to now sound engineers have used conventional 1/3-
octave equalizers to suppress unwanted feedback. Now, the BEHRINGER FEEDBACK DESTROYER PRO
gives you the option to delegate this task to the FEEDBACK DESTROYER PRO, so that you can pay your
music your undivided attention instead of having to suppress feedback with graphic EQs using a trial-and-error
approach.
To fully understand how the BEHRINGER FEEDBACK DESTROYER PRO works you will need to know the
meaning of a few fundamental terms used in signal equalization, such as:
s dB, decibel
s bandwidth / quality factor (Q)
s octave, 1/3-octave
With the FEEDBACK DESTROYER PRO, as with any other type of equalizer, the amount of boost/attenuation
applied to a specific frequency is expressed in decibels (dB). Whats a decibel? The abbreviationdB is not a
unit (although often used as one), but describes a logarithmic proportion. The entire dynamic range of human
hearing (from the threshold of audibility to a jet-airplane, see fig. 4.1) starts with about 0.00002 Pa (threshold of
audibility) and goes up to 113 Pa (threshold of pain).
4. TECHNICAL BACKGROUND