Filter
Top Products
130
Using the Mastering Tool Kit
Modifying Mastering Tool Kit
settings (Edit)
Each of the effect blocks that make up the Mastering Tool Kit
can be fine-tuned by making the appropriate settings.
Before starting, however, you will need to select the Mastering
Tool Kit patch whose settings you would like to change.
1.
Press [F2] (EDIT) on the Mastering Tool Kit patch screen.
The Mastering Tool Kit edit screen will appear.
fig.36-02d
The left half of this screen will display the way in which
effect blocks are connected in this patch; the right half
will display the parameter settings for the effect block
currently highlighted by the cursor.
2.
Move the cursor to the effect block you want to edit and
press [F3] (=>PRM.).
The cursor will jump to the parameter area on the right
of the screen, and you will now be able to change the
parameter settings.
fig.36-02ad
For more detailed information regarding settings, refer
to “Mastering Tool Kit parameter functions” (p. 134).
3.
Move the cursor to the parameter that you want to change
and select a new value using the TIME/VALUE dial.
4.
If you also want to edit other effect blocks, press [F2]
(BLOCK<=) to move the cursor to the left of the screen,
and then repeat Steps 2 and 3.
Note that you can press CURSOR [ ] or [ ] to jump
to the parameter setting screen for the next effect block to
the left or right.
5.
Press [EXIT/NO] to return to the Effects Patch screen.
fig.36-03d
In order to indicate that the Mastering Tool Kit settings
have been temporarily changed, the patch number will
be displayed as “TMP.” If you select a different patch,
load a different song, or turn off the BR-1600CD while
“*TMP” is being displayed, all of the patch settings will
return to their original condition. As it may not be
possible to restore these settings, due caution should be
observed.
To save your modified settings, carry out the procedure
described below in “Saving Mastering Tool Kit settings.”
BR-1600_R_e.book 130 ページ ２００７年１２月６日 木曜日 午前９時５２分