Filter
Top Products
E-37
1.Check to make sure that the digital piano’s POWER button
is in the OFF position. If it is ON, press the button to switch
it OFF.
2.Attach the power cord that comes with the digital piano to
the bottom of the digital piano.*
3.Plug the digital piano’s power cord into a wall outlet (Figure
9).
* applies to the AP-38V.
IMPORTANT!
• The shapes of the digital piano’s power cord and wall out-
let should be different according to countries or regions.
The illustrations are examples.
• With the AP-38, the power cord is hard-wired to the bottom
of the instrument.
3 Connecting the Pedal
Figure 8
Figure 9
3 Connecting the Pedal
Clip
K
Pedal plug
Position the pedal plug as shown in Figure 8 and insert it
into the pedal connector on the bottom of the digital piano.
Secure the pedal cable to the upright of the stand using the
K clips that you installed when assembling the stand (Figure
8).
4 Connecting to a Power Supply
Power cord
Household
wall outlet
Caution
The screws that you use to assemble the stand may
become loose after a long period due to changes in
temperature and humidity, or vibration caused by
normal use, etc. Periodically check the screws used to
fasten the stand and the butterfly bolts used to fasten
the stand and the digital piano, and tighten them
whenever necessary.
428A-E-041A
AP38_e_34-39.p65 02.6.12, 15:5537