Filter
Top Products
Using an SD Memory Card
E-43
Use the procedures in this section to format an SD
memory card.
IMPORTANT!
• When using an SD Memory card, first be sure to format
the memory card on the digital piano.
• Before performing the procedure below, check to make
sure that the SD memory card does not contain any data
you might need.
• The SD memory card format performed by your digital
piano is a “quick format”. If you want to completely delete
all of the data on the card, format it on you computer or
using some other device.
PREPARATION
• Insert the SD memory card you want to format into the
digital piano’s SD memory card slot. Make sure that the
write-protect switch of the SD memory card is not in the
write-protect position.
To format an SD memory card
1.
Press the FUNCTION button.
• This will cause the button’s lamp to flash.
2.
Press the CARD button.
• This will cause “For” (format) to flash on the display.
3.
Press the S/YES button to start formatting.
• “PLS” (please wait) remains on the display while the
formatting operation is performed. Never try to
perform any other operation on the digital piano
while the memory card is being formatted. The
message “CPL” (complete) will appear on the display
to let you know when the format operation is
complete.
z To cancel the format operation, press the T/NO
button in place of the S/YES button in step 3.
You can save song data that you recorded in the digital
piano’s recorder area or registration data you saved to
the registration area to an SD memory card. Song data
also can be converted to SMF format 0 for storage.
PREPARATION
• Insert an SD memory card that has been formatted on the
digital piano into the digital piano’s SD memory card
slot. Make sure that the write-protect switch of the SD
memory card is not in the write-protect position.
IMPORTANT!
• Never turn off the digital piano or perform any other
operation while data is being saved to an SD memory
card. Doing so can cause SD memory card data to be
deleted and make impossible to store data to the card.
To save recorder area data
1.
Press the RECORDER button so the PLAY
lamp is lit.
2.
Use the T/NO and S/YES buttons to display
the song number (1 through 5) of the song
you want to save.
3.
Hold down the CARD button until its lamp
starts to flash slowly and “Ldr” (load recorder
area) appears on the display.
4.
Press the CARD button again.
• This will cause the CARD button lamp to flash at a
higher speed and “SvC” (save as CSR file) to appear
on the display. This setting will save song data in
CASIO CSR format.
• If you want to save the song data in SMF Format 0,
press the CARD button again. This will cause “SvS”
(save as SMF0 file) to appear on the display.
Formatting an SD Memory
Card
Saving Recorded/Registration
Data to an SD Memory Card
PX320_e.book 43 ページ ２００７年８月１日 水曜日 午前９時２８分