Filter
Top Products
Using an SD Memory Card
E-45
You can use the procedures in this section to transfer
data from an SD memory card to the digital piano user
area,
*1
recorder area,
*2
or registration area.
*3
*1 Music Library Songs 61 to 70
*2 Memory area where songs recorded on the digital
piano are stored.
*3 Memory area where registration data on the piano
is stored.
z Supported Data
User Area.............SMF format data and song data
converted using SMF conversion
software (CASIO CM2 format)
Recorder Area
.......Song data recorded on the digital
piano (CASIO CSR format)
Registration Area
...Registration data saved with the
digital piano (CASIO CR6 format)
PREPARATION
• Insert the SD memory card, which contains the data you
want to transfer, into the piano’s SD memory card slot.
IMPORTANT!
• Never turn off the digital piano or perform any other
operation while data is being recalled from an SD
memory card. Doing so can cause SD memory card data
to be deleted or damaged, making transfer of the data
impossible. It also can cause deletion of data stored in
the area to which you are saving the data.
To transfer song data from an SD memory
card to the digital piano user area
1.
Press the MUSIC LIBRARY button so the
lamp below the button is lit.
2.
Use the T/NO and S/YES buttons to display
the number of the user area song (Music
Library song number 61 through 70) to which
you want to transfer the song data.
3.
Hold down the CARD button until its lamp
starts to flash slowly and “LdU” (load user
area) appears on the display.
4.
Use the T/NO and S/YES buttons to display
the file number of the song data you want to
transfer to digital piano memory.
5.
When everything is the way you want, press
the FUNCTION button to begin data transfer.
• The message “CPL” (complete) will appear on the
display to let you know when data transfer is
complete. After that, the display will change to show
the number of the user area song to which the data
was transferred.
z To interrupt an ongoing data transfer operation,
press the CARD button.
z If the user area song number you select contains data
already, pressing the FUNCTION button in step 5
will display “rEP” (replace) to confirm that you want
to replace the existing data with the data you are
transferring. Press the S/YES button to overwrite
the data or the T/NO button to cancel.
Transferring Data from an SD
Memory Card to Digital Piano
Memory
This mark indicates that the currently displayed user area
song number has data stored already.
PX320_e.book 45 ページ ２００７年８月１日 水曜日 午前９時２８分