Filter
Top Products
E-18
419A-E-020B
NOTE
• You can also use the dial to change the tempo setting while
the current setting is indicated by a value in brackets ([ ]) on
the display.
Example: [T:120]
• The value indicates the number of beats per minutes.
• To return the tempo to its initial default setting, press the
TEMPO and buttons at the same time.
• At their initial default tempo setting, some Piano Group tunes
may change tempo part way through. After you change the
tempo setting for such a tune, playback will proceed at the
tempo you selected, from the beginning of the tune to the
end.
Pausing Playback
1
While a tune is playing, press the PAUSE button.
• This pauses playback.
2
Press the PAUSE button again to restart playback from
the location where it was paused.
Skipping Back through a Tune
1
While playback is in progress, hold down the REW
button.
• This skips back through the tune measure-by-measure.
• The measure number and beat number appear on the
display while you are skipping back.
2
When you reach the point you want, release the REW
button to resume playback.
NOTE
• Depending on what is being played when you press the REW
button, the skip back operation may not start right away when
you press it.
Playing Back Built-in Tunes
006 : 1
Beat numberMeasure number
Skipping Forward through a Tune
1
While playback is in progress, hold down the FF button.
• This skips forward through the tune measure-by-measure.
• The measure number and beat number appear on the
display while you are skipping forward.
2
When you reach the point you want, release the FF
button to resume playback.
Looping a Musical Phrase
You can select one or more measures and “loop” them, which means
that they play again and again until you stop playback.
1
While the tune is playing, press the REPEAT button while
the measure you want the phrase to start from is playing.
• This causes the REPEAT indicator lamp to flash.
2
When playback reaches the measure you want to
specify as the end of the loop, press the REPEAT button
again.
• This starts repeat play of the loop.
• To cancel repeat play of a loop, press the REPEAT button
again so its indicator goes out.
Changing the Melody Tone of a
Tune
You can select any one of the digital piano’s 248 built-in tones as
the melody tone of a built-in tune. You can even change the melody
tone setting while playback is in progress.
1
Press a TONE button.
2
Use the dial to select the tone you want.
NOTE
• You can return a tune to its preset default tone by selecting
the tune again.
003 : 1
Beat numberMeasure number
PX400R_e_17-28.p65 04.8.24, 4:34 PM18