Filter
Top Products
E-22
Configuring Settings with the Keyboard
1.
Use the “Keyboard Setting Reference” on
page E-23 to find the setting you want to
configure, and note its keyboard key.
Example: To change the key, you would need to use the
keyboard key labeled TRANSPOSE
2.
While holding down the TEMPO/SETTING
button, press the keyboard key for the setting
you want to configure. In this example, we will
press the TRANSPOSE key. Keep the
TEMPO/SETTING button depressed until you
finish step 3 of this procedure.
• The TEMPO/SETTING button lamp will flash and
the current setting of the item you are configuring
will appear on the display.
3.
Use the + and – buttons to change the
setting.
Example: Lower the TRANSPOSE by one semitone by
changing the displayed value to –1.
4.
Release the TEMPO/SETTING button to
complete the setting procedure.
• This causes the indicator lamp above the button to
turn off.
NOTE
• Pressing the + and – buttons at the same time will change
the displayed setting to its default value.
Pressing the TUNE/OTHERS key in step 2 of the above
procedure will toggle between the two settings
described below.
Pressing the MIDI/OTHERS key in step 2 of the above
procedure will cycle between the two settings
described below.
To configure settings with the
keyboard
To configure a setting using
the TUNE/OTHERS key
To configure a setting using
the MIDI/OTHERS key
Tuning setting
Pre-count setting
(“P” stands for “Pre-count”.)
Send Channel setting
(“C” stands for “Channel”.)
Local Control setting
(“L” stands for “Local”.)
PX800_e.book 22 ページ ２００６年１０月１２日 木曜日 午後１２時５分