Filter
Top Products
E-24
Configuring Settings with the Keyboard
■ Tones
*Display Indicator
■ Song/Metronome
To change this
setting:
Use this keyboard
key:
Settings Description
Tone selection TONE See “Tone List” on
page A-1.
See page E-8.
Layered tone volume
balance
LAYER BALANCE –24 to 0 to 24 Specifies the volume balance between layered tones.
A lower value reduces the volume level of the
layered tone.
Split on/off SPLIT ON/OFF on: On, oFF: Off See page E-10.
Split point SPLIT POINT A0 to C8* Specifies the location of the keyboard split point.
The selected keyboard key is the lowest note of the
high range (right) keyboard.
Brilliance BRILLIANCE –3 to 0 to 3 See page E-9.
Reverb REVERB oFF (Off), 1 to 4 See page E-11.
Chorus CHORUS oFF (Off), 1 to 4 See page E-11.
DSP EFFECT on: On, oFF: Off See page E-12.
Acoustic Resonance EFFECT on: On, oFF: Off See page E-12.
Display
Settings ABCDEFGF
I
3B
i
5
To change this
setting:
Use this keyboard
key:
Settings Description
Tempo TEMPO 20 to 255 Specifies the tempo of Music Library songs, the
metronome, recording and playback, etc.
Metronome beat METRONOME BEAT 0, 2 to 6 Turns the metronome on or off.
Metronome volume METRONOME
VOLUME
0 to 42 Specifies the metronome volume.
Song volume SONG
VOLUME
0 to 42 Specifies the volume of built-in song playback,
independent of overall volume control using the
VOLUME controller.
Pre-count TUNE/OTHERS P.on: On
P.oF: Off
Turns the pre-count before playback of a Music
Library song on or off. When configuring this
setting, use the procedure under “To configure a
setting using the TUNE/OTHERS key” on page E-
22.
NOTE
• When playing a song from the user area or from
an SD memory card, the pre-count may not
sound, even though the pre-count setting is
turned on.
PX800_e.book 24 ページ ２００６年１０月１２日 木曜日 午後１２時５分