Filter
Top Products
E-32
Using an SD Memory Card
To transfer song data from an SD memory
card to the recorder area
1.
Press the RECORDER button so the PLAY
lamp is lit.
2.
Use the + and – buttons to display the
number of the recorder area song (1 through
5) to which you want to transfer the data.
3.
Hold down the CARD button until its lamp
starts to flash slowly and “Ldr” (Load recorder
area) appears on the display.
4.
Use the + and – buttons to display the song
number of the data you want to transfer to
digital piano memory.
5.
When everything is the way you want, press
the TEMPO/SETTING button to begin data
transfer.
• The message “CPL” (ComPLete) will appear on the
display to let you know when data transfer is
complete. The number of the recorder area to which
the data was transferred will be shown on the
display.
z To interrupt an ongoing data transfer operation,
press the CARD button.
z If the recorder area song number you select already
contains data, pressing TEMPO/SETTING in step 5
will display “rEP” (rEPlace) to confirm that you
want to replace the existing data with the data you
are transferring. Press the
S
SS
S/YES button to replace
the data. To cancel the operation, press the
T
TT
T/NO
button in place of the
S
SS
S/YES button.
You can save song data that you recorded on the digital
piano to an SD memory card as SMF Format 0 data or
CASIO CSR data.
PREPARATION
• Insert an SD memory card that has been formatted on the
digital piano into the digital piano’s SD memory card
slot. Make sure that the write-protect switch of the SD
memory card is not in the write-protect position.
IMPORTANT!
• Never perform any operation on the digital piano while
data is being saved to or transferred from an SD memory
card. Performing any operation can cause SD memory
card data to be deleted or damaged, making transfer of
the data impossible.
1.
Press the RECORDER button so the PLAY
lamp is lit.
2.
Use the + and – buttons to display the song
number (1 to 5) of the song you want to save.
3.
Hold down the CARD button until its lamp
starts to flash slowly and “Ldr” (Load recorder
area) appears on the display.
4.
Press the CARD button again.
• This will cause the CARD button lamp to flash at a
higher speed and “SvC” (Save as CSR file) to appear
on the display. This indicates that the song will be
saved as CASIO format CSR data.
• If you want to save the song as SMF Format 0 data,
press the CARD button again. This will cause “SvS”
(Save as SMF0 file) to appear on the display.
This mark indicates that the currently displayed song number
has data stored already.
Saving Song Data Recorded
on the Digital Piano to an SD
Memory Card
PX800_03_e.fm 32 ページ ２００６年１０月１３日 金曜日 午後１２時４９分