Filter
Top Products
E-57
Synthesizer Mode
735A-E-059B
DSP Settings
Use the DSP editing screen to select the DSP type and to edit
parameters.
1
Select a tone, press the SYNTH button, and then
configure parameter settings.
2
After everything is the way you want, press the [̄]
CURSOR button once.
• This advances to the DSP parameter editing screen.
• Pressing the [̆] CURSOR button returns to the
Synthesizer Mode parameter screen.
This setting specifies DSP parameters. See “DSP Parameters”
on page E-33, “Effect List” on page A-17, and “DSP Algorithm
List” on page A-19 for more information.
NOTE
• If you store an original tone with the DSP line turned on
(page E-56), simply recalling the tone automatically
changes the DSP line, DSP type, and DSP parameter
settings. This simplifies the recall of original tones that
include a DSP effect.
User Tone Creation Hints
The following hints provide helpful advice on making user
tone creation a bit quicker and easier.
Use a preset tone that is similar to the one you are trying to
create.
Whenever you already have a rough idea of the tone you are
trying to create, it is always a good idea to start with a preset
tone that is similar.
■
Experiment with various different settings.
There are no real rules about what a tone should sound like.
Let your imagination run free and experiment with different
combinations. You may be surprised at what you can achieve.
Storing a User Tone In Memory
The following procedure shows how to store a user tone in
memory. Once a tone is stored, you can call it up just as you
do with a preset tone.
To name a user tone and store it in
memory
1
Select a preset tone to use as the basis for the user
tone, press the SYNTH button to enter the
Synthesizer Mode, and make the parameter settings
you want.
2
After making parameter settings to create the user
tone, press [̄] CURSOR button twice.
3
Use [+] and [–] to change the user area tone number
on the display until the one where you want to
store the tone is shown.
• You can select any tone number from 600 to 699.
4
After the tone name is the way you want, press the
[̈] CURSOR button to store the tone.
• Use the [+] and [–] buttons to scroll through letters at
the current cursor location.
• Use the [̇] and [̈] CURSOR buttons to move the
cursor left and right.
• See the page E-103 for information about inputting
text.
SYNTH
CURSOR
[+]
/
[–]
WK3100_e_47-58.p65 04.3.26, 0:11 PM57