Filter
Top Products
E-65
Song Memory Function
735A-E-067B
To record chords with step recording
1
Press the SONG MEMORY button three times to
enter step recording standby, and then use the
number buttons to select the song number (0 to 4).
2
Make the following settings.
• Rhythm number
• MODE button
3
Press the CHORD/TR1 button, which is one of the
SONG MEMORY TRACK buttons, to select Track1.
• When recording starts, the REC indicator flashes on
the display. After a few moments the indicator stops
flashing, and remains on the display.
4
Press the SYNCHRO/FILL-IN NEXT button.
5
Play a chord.
• Use the chord play method that is specified by the
current MODE button setting (Fingered, CASIO
Chord, etc.).
• When the MODE button is set to Normal, specify the
chord using the root input keyboard and chord type
input keyboard. See “Specifying Chords in the
Normal Mode” on page E-66 for details.
* 96 clocks = 1 beat
6
Input the length of the chord (how long it should
be played until the next chord is played).
• Use the number buttons to specify the length of the
chord. See “Specifying the Length of a Note” on page
E-66 for details.
• The specified chord and its length are stored in
memory and the keyboard stands by for input of the
next chord.
• Repeat steps 5 and 6 to input more chords.
Flash
Ste
p
Re c
Ch o r d
Cord name Measure, beat, and clock at
current location*
7
After you are finished recording, press the START/
STOP button.
• This enters playback standby for the song you have
just recorded.
• To play back the song at this time, press the START/
STOP button.
NOTE
• Use the procedure under “Correcting Mistakes While
Step Recording” on page E-69 to correct input mistakes
you make during step recording.
• You can add on to a track that already contains recorded
data by selecting that track in step 3 of the above
procedure. Doing so automatically locates the step
recording start point at the first beat immediately
following the previously recorded data.
• Inputting “0” as the chord length in steps 5 and 6 of the
above procedure specifies a rest, but the rest is not
reflected in the accompaniment contents when the
accompaniment is played.
Track 1 Contents After Step
Recording
In addition to chords, the following data is also recorded to
Track 1 during step recording. This data is applied whenever
Track 1 is played back.
• Rhythm number
• INTRO/ENDING 1 button, INTRO/ENDING 2 button,
VARIATION/FILL-IN 1 button, VARIATION/FILL-IN 2
button, SYNCHRO/FILL-IN NEXT button operations
NOTE
• You can also use number buttons 1 through 7, and button
9 to specify the button release timing for the VARIATION/
FILL-IN 1, VARIATION/FILL-IN 2, and SYNCHRO/FILL-
IN buttons. For more information, see “Specifying the
Length of a Note” on page E-66. Specifying release
timing specifies that the applicable button remains
depressed for a particular amount of time. If you do not
specify the release timing, it is assumed that the button
is pressed and then immediately released.
WK3100_e_61-73.p65 04.3.26, 0:11 PM65