Casio WK3000 Musical Instrument User Manual


 
E-96
Inserting and Ejecting a Diskette
The following describes how to insert a diskette into the disk
drive and how to eject it.
To insert a diskette into the floppy disk drive
1
With the label area of the diskette facing up, insert
the diskette shutter first into the disk drive, as shown
in the illustration.
2
Slide the diskette into the drive as far as it will go,
until it clicks into place.
To eject a diskette from the floppy disk drive
IMPORTANT!
Before ejecting a diskette, always check to make sure
that the access lamp is not lit or flashing. A lit or flashing
access lamp means that the keyboard is performing a
data read or write operation. Ejecting a diskette while it
is being accessed can cause its data to become
corrupted.
1
Press the Eject button.
This causes the diskette to be partially ejected from
the disk drive.
2
Remove the diskette from the drive by hand.
Using External Storage Media
This section explains how to use SmartMedia cards and
floppy diskettes (WK-3500 only) for data storage. In this
manual, SmartMedia cards and floppy diskettes are
collectively referred to as external storage media.
NOTE
Layer, split, and Auto Harmonize are automatically turned
off while external storage is being used. Tone and rhythm
selection, and rhythm playback are also all disabled.
Basic SmartMedia Card Operation
1
Insert the SmartMedia card into the card slot.
2
Enter the Card Mode.
* WK-3500
Press the DISK/CARD button twice.
This causes a pointer to appear next to the DISK/
CARD on the display, and also displays Card in the
displays text area.
* WK-3100/WK-3000
Press the CARD button.
This causes a pointer to appear next to the CARD on
the display, and also displays Card in the displays
text area.
3
Press the [̄] CURSOR button to display the Card
Mode menu.
Saving Data
735A-E-098C
CURSOR
DISK/CARD
WK-3500
WK-3100/WK-3000
CARD
Eject button
[+]
/
[]
WK3100_e_89-105.p65 04.3.26, 0:11 PM96