Filter
Top Products
11
Getting Started Connections Basic Operations Specifi cations Troubleshooting
Effector Function Fader Start UtilityUSB
Basic Operations
ENGLISH
MIC (mic input)
1
When a microphone is connected to MIC1 or MIC2,
press the
MIC1 or MIC2 button to set it to ON.
2
Adjust the MIC1 volume level using the MIC1 TRIM
control, and adjust the MIC2 volume level using the
MIC2 TRIM control.
•
While inputting audio signals, if the SIG/PK LEDs
occasionally light up red and then amber, the suitable level
has been reached without any distortion.
3
Adjust the sound quality using the MIC EQ controls
(HI, LOW).
4
To add the effect functions to the mic input, press
the MIC EFX INS buttons to switch them ON.
Ducking function
5
To enable the ducking function, set the DUCKING
button to ON. The button will light.
•
This function detects the mic input and attenuates the level
of the music signals in the master output. It prevents the
sound from the microphone from being drowned out by
the music when a microphone is used.
•
The attenuation level of the master output while the
ducking function is operating can be set within a range
from –30 dB ± 10 dB in the Utility mode.
MONITOR (headphones output)
1
Select the source to be monitored using the CUE
buttons for each channel.
•
When selected, the CUE button lights.
•
CUE monitors for channels 1–4 as well as EFX can be
selected.
2
Use the SPLIT CUE button to select the STEREO/
SPLIT CUE mode.
•
When selected, the SPLIT CUE button lights.
•
In the SPLIT CUE (monaural) mode, the signal selected
for cue is output to the left speaker of the headphones,
and the master signal is output to the right speaker of the
headphones.
•
In the STEREO mode, the master signals and signals
selected for cue are output in stereo.
3
Use the PAN control to adjust the balance between
the CUE signals and master output signals.
•
When it is turned to the left, only the CUE signals are
output from the headphones.
•
When it is turned to the right, only the master signals are
output.
4
Use the LEVEL control to adjust the headphone
output level.
NOTE
To prevent hearing loss, do not raise the volume level excessively
when using headphones