Filter
Top Products
13
Getting Started Connections Basic Operations Specifi cations Troubleshooting
Effector Function Fader Start UtilityUSB
Effector Function
ENGLISH
Effecter Operations
Selecting the effector units and channels
With the input channels:
Using the
EFX SEND button, select the effect units to be used. The
same effect can be selected for a multiple number of channels.
With the mic input and master output:
Using the
EFX INS button, select the effect unit to be used. The
insertion operation is initiated and just the one channel is selected.
Setting the BPM
1
When the auto BPM counter is off, press the TAP
button for over 1 second to turn the auto BPM
counter on.
2
When the auto BPM counter is on, press the
TAP button and release it immediately. The data
measured with the auto BPM function is locked.
•
The channel for which the effect unit was last selected
using the EFX SEND or EFX INS button takes effect as the
channel used for the auto BPM counter measurement.
3
If the TAP button is pressed down for over 2 seconds,
the BPM value can be set directly by pressing the
BEAT buttons.
4
The BPM value can be set by the interval during
which the TAP buttons are repeatedly pressed.
&'9
4&-&$5
&'9
0/0''
Setting the beat
1
Press the BEAT , buttons to set the number
of beats.
2
When the TIME button is pressed, the mode is
changed to the time input mode.
The time can be adjusted by pressing the BEAT ,
buttons.
3
When the TIME button is pressed again, the number
of beats setting mode is restored.
Selecting the effects
Turn the EFX SELECT controls to select the effect, and press the control
to enter the desired effect.
Turning the effects ON and OFF
When the Effect ON/OFF buttons are pressed, the effect is turned ON
or OFF.