Filter
Top Products
65
P 1201
• Single channel
• Modular controller amp concept
• Input transformer optional (NRS 90208)
• Without controller cards, useable as linear
amp with fixed +6 dBu input sensitivity
P 1202
• Dual channel
• Modular controller amp concept
• Input transformer optional (NRS 90208)
• Without controller cards, useable as linear
amp with fixed +6 dBu input sensitivity
Modular P-Series amplifiers guarantee the same quality and
performance standards as linear P-Series amplifiers but are
designed for dedicated EV systems such as the QRx Series.
They combine highest-quality signal control, maximum
speaker-operation safety, and the extreme reliability of linear
P-Series amps within a modular controlled amplifier concept.
This all adds up to maximum flexibilty and an economic
alternative to digitally controlled amp racks. Rear-rackmount
kits ar
e available in a 15.5-inch version (NRS 90235) or 18-
inch version (NRS 90223) to help stabilize the rack frame
and ensure safe transportation.
Precision Series
™
Modular Amplifiers
P 1201 P 1202
Continous rated power (1k Hz, THD 1 %)
2 ohms 1600 watts 850 watts
4 ohms 1200 watts 600 watts
8 ohms 750 watts 380 watts
Continous rated power (20 - 20k Hz, THD < 0,2%)
4 ohms 1000 watts 500 watts
8 ohms 500 watts 300 watts
Max. bridged output
4 ohms N/A 1700 watts
8 ohms (single channel!) 1200 watts
Slew rate > 40 V / µs > 30 V / µs
Total Harmonic Distortion < 00.5% < 0.05%
Intermodulation Distortion (SMPTE) < 0.08.% < 0.08%
DIM 30 < 0.03% < 0.03%
Damping factor 100 Hz / 1000 Hz > 300 / > 200 > 300 / > 200
Crosstalk (at 1 kHz) --- ---
Signal-to-noise ratio (dB A-weighted) > 106 dB > 106 dB
Input Impedance (20-20k Hz, balanced) 20 kohms 20 kohms
Input Sensitivity (without module) 6 dBu fix 6 dBu fix
Input connectors, parallel out XLR in/out XLR in/out
Output connectors Speakon (Pin 1) Speakon (Pin 1)
Dimensions mm (H x W x D) 133 x 483 x 390 mm 133 x 483 x 390 mm
5.2” x 19” x 16.8” 5.2” x 19” x 16.8”
Net weight (without modules) 17 kg (37.5 lbs.) 17 kg (37.5 lbs.)
P1202/P1201
Control Modules
These controller cards provide customized sys-
tem equalization, cr
ossover design, and EV´s
unique voice-coil protection circuit (VCP) for use
with EV loudspeakers (modules for QRx speak-
ers are currently available). Cards for full-range
systems featur
e a switchable 3,000 Hz (Q = 1, -
3 dB) DIP-EQ and a flush-mounted operation
mode switch. Each module also includes a “1-
in-2” switch on the PCB board, allowing it to
drive both channels of a P1202 independently
while using only one controller card. Note that
when a module is used, the amplifier
’
s input
sensitivity changes to 0 dBu.
M-112 M-115 M-212 M-LMH
Dedicated for Rx-112/75 Rx-115/75 Rx-212/75 12/15-2
Operation function Full-range / Mid-High Full-range / Mid-High Full-range / Mid-High Full-range / Mid-High
Frequency Response (-6 dB) 27 - 50k Hz 25 - 50k Hz 27 - 50k Hz 27 - 50k Hz
Full-range mode
Frequency Response (-6 dB) 75 - 50k Hz 75 - 50k Hz 75 - 50k Hz 75 - 50k Hz
Mid-High mode
Adjustable gain-range - 85 dB to + 6 dB - 85 dB to + 6 dB - 85 dB to + 6 dB - 85 dB to + 6 dB
S/N Ratio < 105 dB < 105 dB < 105 dB < 105 dB
THD + N < 0.05% < 0.05% < 0.05% < 0.05%
M-118S
M-215S
M-218S
M-SUB
Dedicated for
Rx-118S
Rx-215S
Rx-218S
18”
Operation function
Subwoofer
Subwoofer
Subwoofer Subwoofer
Fr
equency Response (-6 dB) 25 - 90k Hz 25 - 90k Hz 25 - 90k Hz 25 - 90k Hz
Full-range mode
Fr
equency Response (-6 dB)
---
---
---
---
Mid-High mode
Adjustable gain-range
- 85 dB to + 6 dB
- 85 dB to + 6 dB
- 85 dB to + 6 dB - 85 dB to + 6 dB
S/N Ratio < 108 dB < 108 dB < 108 dB < 108 dB
THD + N < 0.05% < 0.05% < 0.05% < 0.05%