Filter
Top Products
RECLEV
RV AGC
RVOL34
Record Level Menu Display
Record Level Setting
Record Level Set To AGC
20
Recording Level Menu
This menu will not be available if ‘Enable Configuration changes in DRM’ was set to
‘No’ when the configuration file was defined in FlashMic Manager.
The audio level used during recording will be that defined within FlashMic Manager for
the preset being used. The Recording Level menu permits this level to be altered.
To enter the Recording Level Menu, enter MENU mode by pressing the M/STOP
button, and then make SHORT DOWN TURNs of the jogswitch until the display
shows RECLEV.
The units used are in dBs; 01 = min, 40 = max.
When the record level is reduced to ‘zero’, the AGC system is selected.
In this mode, FlashMic automatically adjusts recording level according to the sound
level. In most situations, this ensures that a recording of usable level will be made,
but as with all automatic gain systems, a degree of background noise “pumping” may
be audible on the recording.
It is also possible to adjust the FlashMic’s recording level whilst recording. See
Adjusting Record Level on page 13.
Note that the record level always resets to the last value used when the FlashMic is
switched on, and not to the value set as part of the preset.
Select this with a SHORT PRESS, and the display shows either RVOLnn - where nn =
the current level – or RV AGC if automatic adjustment of recording level was defined
for the current preset.
The recording level can now be adjusted with SHORT UP or DOWN TURNS. A
SHORT PRESS selects the new level.