Filter
Top Products
!
!
!
7
Batteries
The FlashMic requires two AA-size batteries. Either 1.5v alkaline or 1.2v NiMH
(nickel metal hydride) rechargeable batteries may be used.
Batteries of at least 1500mAh capacity are recommended.
Do not use zinc chloride batteries.
Inserting Batteries
Hold the FlashMic in one hand and unscrew the rear
section (the section with the display and operating
controls) with the other.
Slide the rear section back as far as it will go.
Open the hinged plastic battery compartment
cover.
Insert the two batteries oriented as shown on the
compartment cover.
Always change both batteries at the same time, and always use two batteries of the
same brand and type. NEVER mix alkaline and rechargeable batteries.
The two batteries must point the same way.
Close the cover, push the rear section back over the compartment, and screw up
tight.
Note: If changing alkaline batteries, dispose of the old ones in a responsible manner
– always observe local environmental guidelines.