Filter
Top Products
TIMDAT
Clock Set Menu Display
23
Clock Set Menu
The FlashMic contains a real-time calendar/clock, which allows a date and time
‘stamp’ to be embedded in the audio file headers. This is a great aid to later accurate
identification of what may be many similar-sounding recordings made in the field.
The clock runs continuously whilst batteries are fitted. It continues to run for approx.
1 minute after the batteries are removed, allowing time for a change of batteries. If
the batteries are removed for a longer period, or before the FlashMic is used for the
first time, the clock will need to be set to the correct date and time of day.
Note that the FlashMic is perfectly usable without the clock being set accurately;
the only consequence is that the file date/time information will be incorrect (though
intervals between file creation times will be accurate).
To enter the Clock Set Menu, enter MENU mode by pressing the M/STOP button,
and then make SHORT DOWN TURNs of the jogswitch until the display shows
TIMDAT.
After setting all the date and time parameters, the LCD display returns to the
opening TIMDAT screen; the menu system can then either be exited by pressing M/
STOP, or another menu option can be selected with the jogswitch.
Select this with a SHORT PRESS, and the display shows Y yyyy, where yyyy is the
year. This can be altered up or down with SHORT TURNs of the jogswitch. A SHORT
PRESS selects the setting, and the display will now show in turn MON mm, where mm is
the number of the month of the year; DAY dd, where dd is the day of the month; HH
hh, where hh is the hour of the day (note that FlashMic uses a 24-hr. clock); MM mm
for minutes, and SEC ss for seconds. Each of these can be altered in the same way
as the year. The full sequence is show below.
TIMDAT
ê
Y 2006
ê
MON 04
ê
DAY 06
ê
HH 23
ê
MM 00
ê
SS 25
Set Year
Set Month
Set Day
Set Hour
Set Minutes
Set Seconds