Filter
Top Products
52
6. Press the AX3000G’s WRITE button to begin transmitting. When transmitting
is completed, the display will indicate “COMPLETE,” and you will return to the
screen of step 4. (While “DUMP ALL” is being transmitted, the display will indi-
cate “SEND.”)
NOTE: While data is being transmitted, do not touch the buttons or knobs of the
AX3000G or its foot controller, and never turn off the power.
RESTORING
1. Connect the transmitting device’s MIDI OUT to the AX3000G’s MIDI IN.
2. Set the transmitting MIDI device and the AX3000G to the same MIDI channel.
If the AX3000G will be receiving data that was previously transmitted to the
external MIDI device, select the same MIDI channel as was used when trans-
mitting.
3. Transmit the data dump from the external device.
While the AX3000G is receiving all data, its display will indicate “RECEIVE.”
When reception has been successfully completed, it will indicate “COM-
PLETE.” If an error occurs, the display will indicate “ERROR”; in this case, try
transmitting the data again.
NOTE: For details, refer to the owner’s manual of the device that will be transmit-
ting the data dump.
NOTE: While data is being transmitted, don’t touch the AX3000G’s buttons, pedals,
or knobs, and never turn off the power.
4. If you received data for a single program, select the save-destination bank and
program, and save the data. (p.19)
NOTE: The program data will not be written into the AX3000G’s program memory
unless you store it.
HINT:
If the AX3000G receives all data, all of its data will be overwritten automati-
cally. However, the data currently being edited (i.e., the edit buffer) will not be
affected.