Filter
Top Products
61
5-1. CONTROL CHANGE ( )
Assigning control changes
You can assign control change numbers to
the principal parameters accessed by the
EDIT SELECT 1 and 2 knobs and knobs
1–5.
When you operate a knob that corre-
sponds to one of the parameters shown
below, the assigned control change will be
transmitted. If the microKORG receives
the assigned control change, the param-
eter value corresponding to that knob will
be adjusted.
The default settings of these parameters
are shown on page 56.
Procedure
1
Hold down the SHIFT key and press
the 5 key.
The display will indicate "
."
2
Turn the EDIT SELECT 1 or EDIT
SELECT 2 dial to select the section that
contains the parameter whose control
change you want to specify.
3
Turn each knob to select the desired
MIDI control change number (oFF,
C.00..C.95).
If the specified number is currently
assigned to another parameter, the last
decimal point "." in the display will
light.
4
When you have finished making
settings, press the lit 5 key or the
SHIFT key.
The microKORG will return to its
normal state.
The MIDI "MIDI CH" knobs 1 and 2
will select the control change number
for TIMBRE SELECT and SYNC CTRL.
Assigning control changes
(TIMBRE SELECT) (SYNC CTRL) (SYNC CTRL)
Parameters for which you can assign a control change
1 2
3
1, 4