Filter
Top Products
53
Troubleshooting
If the PX5D does not operate as you expect, please check
the following points first. If this does not resolve the prob-
lem, contact your dealer.
1. Power does not turn on.
•Are batteries installed? Alternatively, is the correct
AC adapter connected to an AC outlet?
2. No sound
•Are your guitar or bass, amp and/or headphones
connected to the correct jacks?
•Is your amp turned on and set correctly?
•Are any cables broken?
•Is the master level of the PX5D set to “0” or to a low
level?
•The VOLUME dial may have been turned down.
•Is the PX5D muted?
Be aware that if all effects are off, the chain display
will disappear, and it will not be possible to distin-
guish Bypass or Mute from the LCD display.
•Dose the LCD display “AUX>USB” in Utility mode?
When “AUX>USB” is displayed, the output of you
guitar sound will be muted.
•Is the volume of your guitar turned down?
3. The volume from the device connected to the AUX
jack is too loud or too soft, or cannot be heard.
• Adjust the output level of the connected device.
Make connections to the headphone jack of the de-
vice, instead of to its line output.
• Are you in Phrase Trainer mode?
Exit Phrase Trainer mode.
•
Are you using a connection cable with a built-in resistor?
4. Effects do not apply
•
Is the PX5D bypassed? (the effect chain will be blinking)
•Are the effects used in the program turned on?
5. Tuner does not work.
• Is the PX5D bypassed or muted?
6. Can’t install the software
• Is the CD-ROM inserted in your CD drive?
Make sure that the CD-ROM is inserted correctly.
• Could the lens of your CD drive be dirty?
Use a commercially-available lens cleaner to clean
the lens.
•Are you attempting to install from a network CD
drive?
This software cannot be installed from a network-
connected CD drive.