Filter
Top Products
54
•Are you able to use USB?
If you are using Windows XP, go to [Control Panel]
→ [System], and select the [Hardware] tab. In [De-
vice Manager], check the settings for Universal Seri-
al Bus Controller and USB Root Hub.
7. Can’t record using the USB audio function. Or, the
recording level is too low (too high).
•Use the Utility mode “USBSEND” setting to adjust
the input level to your computer. ☞p.35
8. Can’t play back using the USB audio function. Or,
the playback level is too low (too high).
•Use the Utility mode “USB RCV” setting to adjust
the input level to the PX5D. ☞p.35
9. Your software does not respond to the PX5D
•Is the USB cable connected correctly?
•Did you install the driver you need?
•Has your computer detected the connected PX5D?
If you are using Windows XP, go to Control Panel →
“Sounds and Audio Devices Properties” and click
the Hardware tab.
If you are using Mac OS X, go to Macintosh HD →
Application folder → Utility folder → “Audio MIDI
Settings,” select the “MIDI Devices” tab, and check
that the PX5D has been detected.
•The connected device or software may not support
the messages you are transmitting. Refer to the own-
er’s manual of the connected device or software to
verify that it responds to the messages you are trans-
mitting.