Filter
Top Products
11
CP-3 Digital Surround Processor
Controls and
Indicators
5. Bank
The BANK button switches
between the three register
banks: the Presets and the
two User register Banks (A &
B) where customized modes
may be stored. The mode
number doesn’t change: if
you are using Preset 9,
pressing BANK once
switches to User A9, press-
ing BANK again switches to
USER B9, and pressing
BANK once more selects
Preset 9.
6. Parameter
The three parameter buttons
allow selection and adjust-
ment of variable parameters
within each mode. Pushing
PARAM displays the pa-
rameter menu with a move-
able cursor for 5 seconds;
pushing it again before the
display changes moves the
cursor to the next parameter.
Pressing PARAM ▲ or ▼ will
display and adjust the cur-
rent parameter (whether or
not PARAM has been
pushed.) A single push of ei-
ther of these buttons displays
the parameter; another push
changes the parameter by
one unit. Holding PARAM ▲
or ▼ for more than 1 second
causes the values to change
rapidly in an auto-repeat
mode.
7. Effects*
▲ and ▼ adjust the level of all
signals added by the CP-3.
8. Mutes
MAIN MUTE turns off all out-
puts and lights both MAIN
and EFX MUTE LEDs. Push-
ing EFX MUTE while in sys-
tem- mute mode turns the
effects alone back on. EFX
MUTE alternately turns off
and on all signals added by
the CP-3. Use it to compare
the sound with and without
CP-3 processing, or as a
simple way to play normal
two-speaker stereo.
9. Balance*
BALANCE: The four balance
buttons adjust the levels of
the rear speakers relative to
the sides and fronts, and the
left/right balance of all speak-
ers: front, sides and rear. It
should be used instead of
the balance control on your
preamp or receiver.
10. Volume*
▲ and ▼ simultaneously ad-
just the level of all channels.
These should be used in-
stead of the volume control
on your preamp or receiver.
11. Input
INPUT buttons 1-4 select the
input source and can be pro-
grammed to automatically
engage the desired operat-
ing mode.
*The first push of either of these
buttons displays the current
value for 2 seconds; another
push during that time increases
or decreases the displayed
value. Holding the button down
for 1 second engages auto-re-
peat, changing values rapidly.
Note: Unless otherwise indicated, all references to the remote control in this manual
refer to the Expanded Remote.