M-Audio DCP-300 Electronic Keyboard User Manual


  Open as PDF
of 62
 
User Guide 27DCP-300
‣ To change the Chorus Type:
While holding the Chorus button, use
the Transpose buttons to select a
Chorus Type.
3
The LCD will show the
current Chorus Depth and Type.
Once you have selected the desired Chorus
Type, let go of the Chorus button, and
resume playing DCP-300.
3
In addition to ve Chorus types, you can also choose from a Flanger and two Delay effects as listed in
the table below.
The following Chorus/Effect Types are available:
• Chorus1
• Chorus2
• Chorus3
• Chorus4
• FBChorus
• Flanger
• ShortDelay
• FBDelay
Each of the 16 voices of DCP-300 will remember its individual Chorus on/off status, Type and Depth
setting, even after turning the Power switch off and on.
TIME OUT!
As you use DCP-300, you may notice there is no “Enter” button. That is because whenever you press
the appropriate Function button(s) to edit a setting such as Time Signature, Octave, Master Tune,
or MIDI Channel (or use the Data Assign function), the selected function will “time out” after three
seconds, automatically accepting whatever selection or change you have made (if any). If you have
made no changes, the LCD will go back to normal after 3 seconds.
Function
CHORUS
TRANS
✔
 previous next