Filter
Top Products
12
Global Menus
The following Control Panel features are available on all pages of the Control Panel:
< Mixer Settings – The reset button returns the Control Panel settings to their default values. The Default Values for the Ozonic Control Panel
are listed at the end of this section.
The load, save and delete buttons will open a Windows or Mac file dialog box. To save a set of Control Panel settings, click the save button.
Then, from the Save dialog box, name the setting and click “OK.” After you have saved a set of Control Panel settings, clicking the
load button
will allow you to select and load your saved settings. To delete saved settings, click the
delete button and select the setting that you wish to
delete.
Mixer Page
The mixer page provides output routing and control of the Ozonic’s analog inputs and software returns. There are up to four virtual channels
returning from your Digital Audio Workstation software.
< Software Returns – The mixer page provides up to four virtual audio returns from your audio application, displayed in channel pairs.
These returns will appear in your audio program’s output assignment and mixer settings as available audio outputs.
It is likely that you will control the software output monitor levels from your audio program’s mixer, and will want to keep the Control Panel
mixer faders at their maximum level. However, you may find it convenient to adjust them here, if, for example, you are setting up a balance
between input levels and sw rtn levels.
In order to route these channels, select the appropriate button in the Channel Strip (either 1/2, for Output pair 1 and 2 or 3/4, for Outputs 3 and
4). By default, software returns 1 and 2 are routed to Output pair 1 and 2; software returns 3 and 4 are routed to Output pair 3 and 4.