Filter
Top Products
p.17
mono input module
1
Insert features
Insert ON switch
The Insert point is located after the EQ and before the Low Pass Filter.
External signal processors can be inserted into the channel via 1/4" TRS
connectors (send and return) on the rear panel.The SEND signal is unbal-
anced and the RETURN can accept both unbalanced and balanced signals.
Insert is switched OUT.Any signal coming into the Insert RETURN
jack is left unused.The Insert SEND jack can be used to derive a post-EQ,
pre-LPF output from the channel without interrupting the channel's normal
signal flow.
Insert is switched IN.The Insert RETURN jack is activated.The
RETURN jack can also be used as an input for situations where the mic
preamp and it's associated features are not required, such as when using an
external mic preamp.
pan control
See description of Bus Assignment features later in this section
safe preview
Safe Preview LED
See LOCAL MICROPROCESSOR CONTROL section
mute
Mute switch
See LOCAL MICROPROCESSOR CONTROL section
write-in label
This label may be written on with a grease-marker, or dry-erase pen and later
wiped clean. Masking tape may also be placed on this surface, if desired. If you
write on it with a "Sharpie", you may have trouble getting the writing off. If this is
the case, your best bet is to wipe the label off with isopropyl (rubbing) alcohol.
LED
If you are using a
something like an
external tube mic preamp,
you can bypass the chan-
nel's input preamp by com-
ing into the insert return
jack.
+