Filter
Top Products
p.57
group module
3
rear panel features
group output
This balanced male XLR connector carries the
GROUP output signal.see—
group fader, front-panel description
group insert point
Separate 1/4" TRS jacks provide the ability to insert an external signal processor
into the signal path of the GROUP. Insert is made active by depressing Group Insert
ON switch.
group insert send
This output connects to the input of an external signal processor. The
signal is derived after the group-summing amplifier. This output is ground com-
pensated.
group insert return
This balanced input accepts a signal from the output of an external sig-
nal processor. It accepts either balanced or unbalanced signals.
aux output
This balanced male XLR connector carries the AUX output signal. see—aux
master,front-panel description
aux insert point
Separate 1/4" TRS jacks provide the ability to insert an external signal processor
into the signal path of the AUX. Insert is made active when a 1/4" TRS connector
is plugged into the Aux Insert return jack.
aux insert send
This output connects to the input of an external signal processor. The
signal is derived after the aux-summing amplifier. This output is ground compen-
sated. It can also be used as pre-aux master level output without interrupting the
normal signal flow through the aux master section.
aux insert return
This balanced input accepts a signal from the output of an external sig-
nal processor. It accepts either balanced or unbalanced signals. Inserting a 1/4"
TRS plug into this jack makes the aux insert active.
group in
External signal can be introduced to the group by plugging a 1/4" TRS
connector into this jack. One primary purpose for the Group in jacks is to link
consoles together. The group outputs from another console can be fed into these
jacks, linking the group buses of the two consoles.