Filter
Top Products
2
p.25
mono input module
rear panel features
direct out 1/4" TRS jack
The input channel's signal is available at this output jack.The default sig-
nal routing is derived post-fader,post-eq and post-mute.This output jack is
ground-compensated.
inser
t points
Separate 1/4" TRS jacks provide the facilities for inserting an external signal
processor into the signal path of the input channel.
insert send
This jack serves as an output for connection to the input of a signal
processor.The signal is derived after the mic preamp and HPF but before the eq
section. Plugging a 1/4" TRS plug into this jack does not break the signal flow of
the channel.This output jack is ground-compensated.
insert return
The output of a signal processor is fed to this jack. It can accept a bal-
anced or unbalanced signal and is located pre-eq.Plugging a 1/4" TRS plug into this
jack breaks the signal flow of the channel.
balanced line-in jack—Bal Line In
Line-level signals, balanced or unbalanced, may be brought into the
input channel through this jack.The
LINE switch must be depressed for this jack to
be active.
balanced mic-in xlr connector—Bal Mic In
This balanced female XLR accepts a low-impedance microphone signal, or
a line-level signal, depending on position of the
LINE switch on the front panel.
see—mono input module, phantom power, line