Filter
Top Products
19
Before You Start Playing
Before You Start Playing
I
If you’re using headphones, you can use the cord hook to
neatly bundle the cables near your feet.
Attaching the Cord Hook
1.
Screw the cord hook (with wing nut) about
80% of the way into the screw hole located at
the bottom left of the ATELIER.
2.
After you’ve oriented the hook as desired, use
the wing nut to fasten it.
The settings stored in the ATELIER can be returned to their
factory settings. This function is called “Factory Reset.”
1.
Turn down the volume to the minimum level,
then turn off the power.
2.
While holding down the [One Touch Program]
button, press the [Power On] switch to turn the
power on.
fig.01-15
Do not turn off the power while the following screen is
displayed.
fig.01-16
When factory reset is completed, the basic screen
reappears.
To return all settings other than the User memory settings to
their original factory conditions, refer to “Panel Reset“ (p.
119).
Loading factory default settings will erase any Registrations
currently in the memory of the ATELIER. It is a good idea to
save important Registrations to USB memory. To save the
registrations you are currently using, refer to “Saving
Registration Sets” (p. 60).
To return only the User memory settings to their original
factory conditions, refer to “User Memory Reset“(p. 119).
Using the Cord Hook
Screwhole
Wing Nut
Code hook
Restoring All the Factory
Default Settings (Factory Reset)
NOTE
NOTE
NOTE
NOTE
AT-100-300_e.book 19 ページ ２００８年５月７日 水曜日 午後３時３３分