Filter
Top Products
101
Chapter 6. Changing Various Settings
Setting the Part to Which
Harmonies Are Added
(Harmony Part)
When “Data” is selected as the Harmony type and you sing
along with the playback of the music data, harmonies
consistent with the scale of the specified part are added (p.
40).
Use the following procedure to set the part to which
harmonies are added.
1.
Press the [Function] (Exit) button, getting its
indicator to light.
2.
Press the [Song] (Select -) button or [ ] (Select
+) button to display the “MISC Harmony Part”
screen.
3.
Press the [ ] (Value -) button or [ ] (Value
+) button to switch the harmonized part.
Value:
1–16
4.
Press the [Function] (Exit) button so the indicator
goes out.
Using the Aux Input Jacks
1.
Press the [Function] (Exit) button so the indicator
is lit.
2.
Press the [Song] (Select -) button or [ ] (Select
+) button to display the AUX INPUT screen.
3.
Press the [Song] (Select -) button or [ ] (Select
+) button to get the value for “Mode” to flash.
fig.
4.
Press the [ ] (Value -) button or [ ] (Value
+) button to change Aux Input type.
Value: Off, Stereo, Decode, Decode A/V Sync
With the factory settings, this is set to “Off.” When set to
“Off,” the Aux Input jacks cannot be used.
Set this to “Stereo” when using a connected MD player or
other such device.
“Decode” and “Decode A/V Sync” are employed when
inputting encoded signals; it is not normally used in normal
situations.
5.
Press the [Song] (Select -) button or [ ] (Select
+) button to get the value for “Level” to flash.
fig.
6.
Press the [ ] (Value -) button or [ ] (Value
+) button to change the Level of the device
connected to Aux Input jacks.
Value: 0–127
* When the level is set to “0,” sounds from the device connected
to the Aux Input jacks are not played.
7.
Press the [Function] (Exit) button so the indicator
goes out.
You can save this setting in the RG-3M’s memory using the
Memory Backup function (p. 75).
RG-3M_e3.book 101 ページ ２００８年３月２５日 火曜日 午前１０時１分