Filter
Top Products
26
Appendices
When practicing with Stroke Balance, if you think that the needle swings too much or too little, then
adjust the head sensitivity.
1.
While simultaneously holding down the [METRONOME] and [COACH] buttons, turn on the
power.
2.
Press the [COACH] button twice.
The display shows “ .”
3.
Press the [+] or [-] button to adjust the sensitivity. (initial setting: 6)
Setting this to a higher value makes the sensitivity higher.
4.
When finished, press the [START/STOP] button.
The setting is stored, and then the RMP-5 returns to the normal screen.
This restores the RMP-5 to the original factory settings.
1.
Hold down the [START/STOP] button and turn on the power.
The display shows “ .”
2.
Press the [START/STOP] button again and keep pressing to restore the factory settings.
All settings are returned to the default factory settings.
When the procedure is finished, the RMP-5 returns to the normal screen.
The RMP-5’s head is set at the factory with the following values.
This section lists the different error messages that may appear, along with their meanings and
measures to resolve the problems described.
Adjusting the Pad Sensitivity
Restoring the Factory Settings
(Sensitivity): 5
(Threshold): 2
(Velocity Curve): Lnr
(Scan Time): 16
(Retrigger Cancel): 3
(Crosstalk Cancel): off
(Mask Time): 4
If an Error Message Appears
Display
Meaning Action
Data in the RMP-5’s memory may be
corrupted.
“ ” appears when the [METRONOME]
button is pressed. Press the [METRONOME]
button once again and keep pressing to exe-
cute the Factory Reset. Only the settings for
the corrupted portion are subject to Factory
Reset (doing so will erase any changes you
have made).
If this does not resolve the problem, consult
your Roland dealer or nearest Roland Service
Center.
A problem has occurred with the in-
ternal system.
Consult your Roland dealer or nearest Ro-
land Service Center.
RMP-5_e.book 26 ページ ２００５年８月１１日 木曜日 午後２時４７分