Filter
Top Products
27
Appendices
If the head has been damaged or no longer maintains correct tension, replace it.
To order replacement heads (#03891812 RMP-3 PAD HEAD(MESH HEAD) <CM-2208-RN>),
contact the retailer from whom you purchased the RMP-5 or the nearest Roland Service Center.
Replacing the Head
When replacing or tuning, use the included tuning key.
fig.HeadChange
1.
Remove all tuning bolts.
Gradually loosen each one in order, turning them
counterclockwise.
* Do not lose the tuning bolts.
2.
Open the case, and then remove the old head.
3.
Place the new head in the case.
4.
Securely close the case.
5.
Attach all eight tuning bolts.
6.
Adjust the tension of the head. Refer to “Adjusting the Head Tension” (p. 7).
Replacing the Head
The MH-8 Mesh Head is not
compatible and cannot be
used.
RMP-5_e.book 27 ページ ２００５年８月１１日 木曜日 午後２時４７分